Accessories - DeWalt DHS790 Guide D'utilisation

CLEANING THE D WALT CORDED POWER SUPPLY
e
WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic parts
of the tool. These chemicals may weaken the plastic materials used in these parts. Use a
cloth dampened only with water and mild soap. Never let any liquid get inside the tool; never
immerse any part of the tool into a liquid.
CLEANING THE CORDED POWER SUPPLY RECEPTACLE
WARNING: Blow debris out of the corded power supply receptacle (BF) with clean, dry
air. To minimize the risk of eye injury, always wear ANSI Z87.1 approved eye protection and
respiratory protection when performing this.
DUST DUCT CLEANING
Depending on your cutting environment, saw dust can clog the dust duct and may prevent
dust from flowing away from the cutting area properly. With the battery pack or corded power
supply removed and the saw head raised fully, low pressure air or a large diameter dowel rod
can be used to clear the dust out of the dust duct.
CUTLINE™ LED WORKLIGHT CLEANING
For the best worklight performance, perform the following maintenance regularly with the
battery or corded power supply removed.
• Carefully clean sawdust and debris from worklight lens with a cotton swab.
• DO NOT use solvents of any kind, they may damage the lens.
• Dust build-up can block the worklight and prevent it from accurately indicating the line of
cut.
• Follow miter saw's instruction manual to remove and install blade.
• With blade removed from saw, clean pitch and build-up from blade. Pitch and debris can
interfere with the worklight and prevent it from accurately indicating the line of cut.

Accessories

WARNING: Since accessories, other than those offered by D
with this product, use of such accessories with this tool could be hazardous. To reduce the
risk of injury, only D WALT recommended accessories should be used with this product.
e
Recommended accessories for use with your tool are available at extra cost from your
local dealer or authorized service center. If you need assistance in locating any accessory,
please contact D WALT Industrial Tool Co., 701 East Joppa Road, Towson, MD 21286, call
e
1-800-4-D WALT (1-800-433-9258) or visit our website: www.dewalt.com.
e
OPTIONAL ACCESSORIES
The following accessories, designed for your saw, may be helpful. In some cases, other locally
obtained work supports, length stops, clamps, etc., may be more appropriate. Use care in
selecting and using accessories.
Extension Used to support long
Work Support: overhanging work pieces,
DW7080 the work support is
user assembled. Your
saw base is designed
to accept two work
supports, one on each
side.
WALT, have not been tested
e
LOCKNUTS
END PLATE
19
Adjustable Length Requires the use of one
Stop: DW7051 Extension Work Support
(DW7080). It is used to
make repetitive cuts of
the same length from 0
to 42" (107 cm).
Clamp: DW7082 Used for firmly clamping
workpiece to the saw
(similar model
table for precision cutting.
included)
Dust Bag: Equipped with a zipper
DW7053 for easy emptying, the
dust bag will capture the
(included with
majority of the sawdust
some models)
produced.
Crown Molding Used for precision cutting
of crown molding.
Fence: DW7084
SAW BLADES: ALWAYS USE 12" (305 mm) SAW BLADES WITH EITHER 1" (25.4 mm) OR
5/8" (15.88 mm) ARBOR HOLES. SPEED RATING MUST BE AT LEAST 4800 RPM. Never
use a smaller diameter blade. It will not be guarded properly. Use crosscut blades only!
Do not use blades designed for ripping, combination blades or blades with hook angles in
excess of 7°.
KNOBS BRACKET