Installation - Sony MEX-XB100BT Mode D'emploi

Installation

Removing the protection collar and the
bracket
Before installing the unit, remove the protection
collar and the bracket
1
Pinch both edges of the protection collar
, then pull it out.
2
Insert both release keys
click, and pull down the bracket
pull up the unit to separate.
Face the hook inwards.
Mounting the unit in the dashboard
Before installing, make sure the catches on both
sides of the bracket
in).
1
Position the bracket
dashboard, then bend the claws outward
for a tight fit.
32
GB
from the unit.
until they
, then
are bent inwards 2 mm (
inside the
182 mm (7
1
53 mm (2 1 / in)
8
Catch
2
Mount the unit onto the bracket
attach the protection collar
CAUTION
Do not touch the left side of the unit when
removing from the dashboard. The heatsink on
the left side of the unit remains hot right after
use.
Notes
 If the catches are straight or bent outwards, the unit
will not be installed securely and may spring out.
 Make sure the 4 catches on the protection collar
are properly engaged in the slots of the unit.
Detaching and attaching the front panel
For details, see "Detaching the Front Panel"
(page 6).
Resetting the unit
For details, see "Resetting the unit" (page 7).
Fuse replacement
/
3
32
When replacing the fuse, be sure to use one
matching the amperage rating stated on the
original fuse. If the fuse blows, check the power
connection and replace the fuse. If the fuse blows
again after replacement, there may be an internal
malfunction. In such a case, consult your nearest
Sony dealer.
/ in)
4
Note
Use an appropriate tool to replace a fuse.
, then
.
Fuse (15 A)