Numark MIX DECK Guide D'utilisation Rapide page 8

PARAMETER KNOB FEATURES
SCRATCH
Holding the SCRATCH button and turning the PARAMETER knob will allow you to choose the desired scratch mode:
Vinyl: This mode allows you to use the JOG WHEEL to scratch just like you would with a vinyl record. When you press
on the JOG WHEEL, the music will stop where it is until the wheel is released.
Forward: When you use the JOG WHEEL to scratch, only the forward motions are heard. This simulates using a
crossfader to cut out the backspins.
Bleep: Allows you to "insert" a scratch while the music continues to advance. One you are done scratching, the music
will continue to play where it would have been if you hadn't scratched.
Bleep Forward: Essentially a combination of Bleep and Forward Scratch Modes. Allows you to "insert" a scratch but
only plays the forward motion of the platter.
PITCH
Holding the PITCH button and turning the PARAMETER knob allows you to change change the key of the current song from
"L" (lower key) to "H" (higher key) in 40 semitone increments (with 0 being no key change).
MODE
To turn Relay Mode on and off, hold the rectangular MODE button and turn the PARAMETER knob to select the appropriate
relay setting. Relay Mode will allow you to alternate play between 2 compatible units connected via a 1/8" mono relay/remote
cable.
SEARCH
Search speed can be adjusted by holding SEARCH and rotating the PARAMETER knob. Options based upon 1 wheel rotation
are 15 seconds, 30 seconds, and 1 minute.
PROGRAM / PARAMETER OPTIONS
Holding the PROGRAM button and turning the PARAMETER knob will bring you to the following menu options. Pressing down
on the PARAMETER knob will allow you to modify the parameters for the menu option that you have selected:
Scratch Delay (On, Off): Activates a slight delay when releasing the platter in Scratch Mode.
Remote (Off, On-Cue, On-Pause): Changes the remote start option to allow the unit to be started by another device
using a remote start cable.
Power On Play (On, Off): When on, this option will cause the CD player to begin playing as soon as the power is turned
on.
Memo All Clear (No, Yes): Clears all stored cue points and loop point information.
Sleep Mode (On, Off): When sleep mode is engaged the unit will go into a "sleep" state after a few minutes of inactivity.
Preset Clear (Yes, No): Reset all global parameters to their default settings.
Version Number: When the PARAMETER knob is pressed, the operating system version numbers will be displayed for
as long as the PROG button is held.
Power On Demo (On, Off): When this option is on, the unit will go into a "demo mode" where the platter LEDs will
illuminate in a pattern as soon as the unit is powered on.
8