Technical Data - Sony MEX-100NV Mode D'emploi

7890_GB.book Seite 140 Montag, 1. Juli 2002 1:20 13

Technical data

Wavebands :
T e c h n i c a l d a t a
:
Frequency range
:
Output power
:
Line cross section
Loudspeaker impedance :
Line out :
GAL :
Aerial :
AF telephone input :
AUX input :
Telephone mute :
Supply voltage :
:
CD connection
:
Playable CDs
140
FM 87.5 MHz - 108 MHz
MW 531 kHz - 1620 kHz
LW 153 kHz - 282 kHz
SW 5800 kHz - 6250 kHz
20 Hz - 20 kHz for CD operation
30 Hz - 15 kHz for FM
50 Hz - 2.5 kHz for MW, LW, SW
4 x 18 Watt
min. 0.75 mm²
min. 4 9
4 x analogue line out (Va max 3Veff at 10 k9)
In order to utilise the GAL, a square wave voltage
with an amplitude of +4 V - +12 V relative to earth, must be available from the electronic
speedometer of the vehicle. The adjustment is performed in 7 steps of 2.5 dB.
Impedance 50 9
Max. input voltage 8 V (if interference occurs, a commercially available 1 : 1 transformer
should be connected into the signal cable).
16 k9input impedance, max. input voltage 1.7 Veff
Low active level < 2 Volt
12 V
Sony optional CD changer CDX-T6NV can be connected.
Only CDs which conform to DIN EN 60908 may be used.
The use of 8 cm CDs with adapter is not recommended.