Service And Repairs - Hitachi NT 1865DMA Manuel D'instructions Et De Sécurité

English
7. Storage
Storing in a place below 104°F (40°C) and out of the
reach of children.
NOTE
Storing lithium-ion batteries
Make sure the lithium-ion batteries have been fully
charged before storing them.
Prolonged storage (3 months or more) of batteries
with a low charge may result in performance
deterioration, signifi cantly reducing battery usage
time or rendering the batteries incapable of holding a
charge.
However, signifi cantly reduced battery usage time
may be recovered by repeatedly charging and using
the batteries two to fi ve times.
If the battery usage time is extremely short despite
repeated charging and use, consider the batteries
dead and purchase new batteries.
8. Service parts list
CAUTION
● Repair, modifi cation and inspection of Hitachi
Power Tools must be carried out by a Hitachi
Authorized Service Center.
This Parts List will be helpful if presented with
the tool to the Hitachi Authorized Service Center
when requesting repair or other maintenance. In
the operation and maintenance of power tools,
the safety regulations and standards prescribed
in each country must be observed.
Maintenance chart
ACTION
Clean magazine and feeder
mechanism.
Keep push lever working properly.
Operator troubleshooting
Most minor problems can be resolved quickly and easily using the table below.
If problems persist, contact a Hitachi authorized service center for assistance.
PROBLEM
Power switch doesn't turn on.
Turn on once, but turn off
automatically.
30
MODIFICATIONS
Important notice on the batteries for the Hitachi
cordless power tools
Please always use one of our designated genuine
batteries. We cannot guarantee the safety and
performance of our cordless power tool when used
with batteries other than these designated by us, or
when the battery is disassembled and modifi ed (such
as disassembly and replacement of cells or other
internal parts).

SERVICE AND REPAIRS

All quality Nailers will eventually require servicing or
replacement of parts because of wear from normal use.
NOTE
WHY
Prevent a jam.
Promote operator safety and effi cient
Nailer operation.
CHECK METHOD
Low battery charge.
Damaged internal electronics.
Push lever and/or trigger is ON state ? Keep push lever and trigger in OFF
Keep no operation over 30 minutes ?
(Auto-power off function)
Hitachi Power Tools are constantly being improved
and modifi ed to incorporate the latest technological
advancements.
Accordingly, some parts may be changed without
prior notice.
WARNING
● Only service personnel trained by Hitachi,
distributor or employer shall repair the Nailer.
● Use only parts supplied or recommended by
Hitachi for repair.
Specifi cations are subject to change without any
obligation on the part of HITACHI.
Blow clean daily.
Blow clean daily.
Charge the battery.
Contact Hitachi for replacement.
state.
Push and hold power switch more
than 1 second to switch "ON"
HOW
CORRECTION