Testing The Nailer - Hitachi NT 1865DMA Manuel D'instructions Et De Sécurité

English
Status of indicator
2 LEDs (Red) light
1 LED (Red) lights
1 LED (Red) blinks
(5) Other functions
In case of operation error, LED lamps show as below.
Status of indicator
LED light
LED light blink in an interval.
• In case of too hot
condition, Blink in
1 second interval.
• In case of too cold
condition, Blink in
0.5 second interval.
After 10 seconds,
automatically turn off LED
light and Power switch.
2 LEDs blink in Orange,
after 10 seconds,
automatically turn off
Power switch.
20
The battery remaining
power is enough.
The battery remaining
power is about half.
The battery remaining
power is nearly empty.
Recharge the battery as
soon as possible.
Machine is in too cold
(below 23°F (-5°C) or too
hot condition.
Allow the nailer to cool
or warm-up thoroughly in
adequate condition.
Contact Hitachi for
replacement.
(6) How to use the LED light
While the power switch on, the LED light will
automatically light up the tip portion of the tool.
Light in green
CAUTION
● Do not expose directly your eye to the light by
looking into the light.
If your eye is continuously exposed to the light,
your eye will be hurt.
● Wipe off any dirt or grime attached to the lens of
the LED light with a soft cloth, being careful not
to scratch the lens.
Scratches on the lens of the LED light can result
in decreased brightness.

TESTING THE NAILER

● Operators
work area MUST wear safety
glasses with side shields
which conforms to ANSI Z87.1
specifi cations.
● Make sure the trigger is locked when not
fi ring nails.
This Nailer has a lock mechanism to prevent the
nails from being fi red.
Set the lock lever at the
trigger.
Slide the lock lever to the
Nailer is to be used, and to the
is not in use.
DANGER
and others
WARNING
position to lock the
position when the
position when it
in