Stihl FS 80 Notice D'emploi page 27

English
Mounting hardware is packed with
the machine
Mowing heads and metal cutting
tools may be mounted.
Mounting hardware is loose
: Pull the hose (1) (protector for
shipping) off the shaft (2).
The nut (3), rider plate (4) and thrust
washer (5) are in the parts kit
supplied with the machine.
: Go to "Mounting the Mowing Head"
or "Mounting Metal Cutting Tools".
Mounting hardware is secured to
gearhead
: Go to "Removing Mounting
Hardware"
26
Removing Mounting Hardware
: Block the shaft – see next section
on "Blocking the Output Shaft".
: Use the combination wrench
unscrew the nut (3) clockwise (left-
hand thread) from the shaft (2).
: Pull the thrust washer (5) off the
shaft (2).
1)
Comes standard with the machine or
is available as special accessory
The rider plate (4) is in the parts kit
supplied with the machine.
: Go to "Mounting the Mowing Head"
or "Mounting Metal Cutting Tools".
Blocking the Output Shaft
8
7
: Insert the stop pin
(7) in the hole (8) in the gearhead as
far as stop – apply slight pressure.
: Rotate nut or cutting tool on the
shaft (2) until the stop pin slips into
position and blocks the shaft.
1)
(6) to
1)
Comes standard with the machine or
is available as special accessory
FS 80, FS 80 R, FS 85, FS 85 R
2
7
1) 1)
or screwdriver