Maintenance; Maintenance Schedule - Husqvarna 435 Manuel D'utilisation

5. Make one or more cuts of sufficient depth necessary
to decrease the tension. Cut at or near the point of
maximum tension. Make the tree or branch break at
the point of maximum tension.
WARNING: Do not cut straight through a
tree or branch that is in tension.
WARNING: Be very careful when you
cut a tree that is in tension. There is a
risk that the tree moves quickly before or
after you cut it. Serious injury can occur
if you are in an incorrect position or if
you cut incorrectly.
6. If you must cut across tree/branch, make 2 to 3 cuts,
1 in. apart and with a depth of 2 in.
7. Continue to cut more into the tree until the tree/
branch bends and the tension is released.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.

Maintenance schedule

Daily maintenance
Clean the external parts of the prod-
uct and make sure that there is no oil
on the handles.
20
8. Cut the tree/branch from the opposite side of the
To use the product in cold weather
1. Clothe a part of the air intake on the starter. This
2. For temperatures below -5°C/23°F or in conditions

Maintenance

Weekly maintenance
Clean the cooling system. Refer to
To clean the cooling system on page
30 .
bend, after the tension is released.
CAUTION: Snow and cold weather can
cause operation problems. Risk of too low
engine temperature or ice on the air filter
and the carburetor.
increases the engine temperature.
with snow, a winter cover is available. Assemble the
winter cover on the starter housing. The winter cover
decreases the flow of cool air and keeps snow away
from the carburetor space.
CAUTION: Remove the winter cover if
the temperature increases above -5°C/
23°F. Risk of too high engine
temperature and damage to the engine.
Monthly maintenance
Do a check of the brake band. Refer
To do a check of the brake band
to
on page 22 .
1270 - 004 - 30.01.2021