Symbols On The Product - Husqvarna 435 Manuel D'utilisation

17. Saw chain
18. Bar tip sprocket
19. Guide bar
20. Spiked bumper
21. Chain catcher
22. Chain tensioning screw
23. Clutch cover
24. Right hand guard
25. Throttle trigger
26. Throttle trigger lockout
27. Operator's manual
28. Combination wrench
29. Guide bar cover

Symbols on the product

WARNING! Be careful and use the product
correctly. This product can cause serious
injury or death to the operator or others.
Read the operator's manual carefully and
make sure that you understand the
instructions before you use this product.
Always wear approved protective helmet,
approved hearing protection and eye
protection.
Use 2 hands to operate the product.
Do not operate the product with one hand
only.
Do not let the guide bar tip touch an object.
Other approved bar and chain combinations
in the operator's manual.
XX
Computed kickback bar stopping angle
without actuated chainbrake, CKA wob.
XX
Computed kickback bar stopping angle with
actuated chainbrake, CKA wb.
1270 - 004 - 30.01.2021
Warning! Kickback can occur when the
guide bar tip touches an object. A kickback
causes a lightning fast reverse reaction that
throws the guide bar up and in the direction
of the operator. Can cause serious injury.
Choke.
Fuel.
Chain oil.
Air purge bulb.
Adjustment of the oil pump.
Chain brake, engaged (right). Chain brake,
disengaged (left).
yyyywwxxxxx
Husqvarna SP33G
10T
16"
Note: Other symbols/decals on the product refer to
certification requirements for certain markets.
EPA III
The Emissions Compliance Period referred to on the
Emission Compliance label indicates the number of
operating hours for which the engine has been shown to
meet Federal emissions requirement. Maintenance,
replacement or repair of the emission control devices
The rating plate showing
serial number. yyyy is the
production year, ww is the
production week.
Recommended cutting
equipment in this exam-
ple: - Guide bar length: 16
inches - Max. nose radius:
10T - Saw chain type:
Husqvarna SP33G
3