Maintenance; General; Checking, Maintaining And Servicing Chain Saw Safety Equipment - Husqvarna T536 LiXP Manuel D'utilisation

Masquer les pouces Voir aussi pour T536 LiXP:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

General

The user must only carry out the maintenance and
service work described in this manual. More extensive
work must be carried out by an authorized service
workshop.
Checking, maintaining and
servicing chain saw safety
equipment
Note! All servicing and repair work on the machine
requires special training. This is especially true of the
machine's safety equipment. If your machine fails any of
the checks described below we recommend you to
contact our servicing dealer.
WARNING! Always remove the battery
!
before any assembly, maintenance and/
or checking is done on the machine.
IMPORTANT! Never clean the battery or the battery
charger with water. Strong cleaning agents can damage
the plastic.
Chain brake and front hand guard
Checking the front hand guard
Li-ion
Li-ion
Make sure the front hand guard is not damaged and
that there are no visible defects such as cracks.
Move the front hand guard forwards and back to make
sure it moves freely and that it is securely anchored to
the machine.
Checking the brake trigger
Activate the chain saw. Make sure the saw chain does
not touch the ground or any other object. See the
instructions under the heading Start and stop.

MAINTENANCE

Grasp the chain saw firmly, wrapping your fingers and
thumbs around the handles.
Apply full power and activate the chain brake by tilting
your left wrist forward onto the front hand guard. Do
not let go of the front handle. The chain should stop
immediately.
Power trigger lockout
Make sure that the power trigger is locked at the idle
setting when the power trigger lockout is released.
Press the power trigger lockout and make sure it
returns to its original position when released.
Check that the power trigger and power trigger lockout
move freely and that the return springs work properly.
Activate the chain saw and apply full power. Release
the power trigger and check that the saw chain stops
and remains stationary.
English
35

Publicité

Table des Matières
loading

Table des Matières