Control Panel - Sony VPL-CS3 Mode D'emploi

How to use the adjuster
To adjust the height
Adjust the height of the projector as follows:
1
Lift the projector and press the
adjuster adjustment buttons.
The adjusters will extend from the
projector.
Adjuster adjustment buttons
2
While pressing the buttons, lower the
projector. Then, release the buttons.
For fine adjustment, turn the adjusters
to the right and the left
to lower
the
projector
Notes
• Be careful not to let the projector down on
your fingers.
• Do not push hard on the top of the
projector with the adjusters out.
It may be occurred malfunction.
10
GB
Location and Function of Controls
to raise the
projector

Control Panel

1 I / 1 1 1 1 (on/standby) key
Turns on and off the projector when the
projector is in standby mode. The ON/
STANDBY indicator lights in green
when the power is turned on.
When turning off the power, press
the I / 1 key twice following the
message on the screen, or press and hold
the key for about one second.
For details on steps for turning off the
power, see "To turn off the power" on
page 21.
2 INPUT key
Selects the input signal. Each time you
press the key, the input signal switches
as follows:
t
INPUT A VIDEO
3 Speakers
4 APA (Auto Pixel Alignment) key
Adjusts a picture clearest automatically
while a signal is input from a computer.
5 ENTER key
Enters the settings of items in the menu
system.
6 MENU key
Displays the on-screen menu. Press
again to clear the menu.
t
S VIDEO