Arktic PROFI LINE 232118 Mode D'emploi page 12

Defrosting
Illuminated – Defrosting in progress
Blinks – Condensing in progress
The Celcius Scale
Illuminated – Unit of measure
Blinks – Programming mode
The Fahrenheit Scale
Illuminated - Unit of measure
Blinks- Programming mode
Cooling Fan
Illuminated – fan activated
Blinks - Time delay of fan activation
7.6. OPERATION OF CONTROL PANEL
EN
7.6.1. CHANGING THE SET VALUE
• In order to display the set value, press and imme-
diately release the SET button.
• Press and hold the
seconds to change the set value. The current set
value will be displayed, and the "°C" or "°F" LED
7.6.2. CHANGING PF THE UNIT OF MEASURE
• To change a parameter value, enter the pro-
gramming mode by pressing and holding the
button for 3 seconds (the "°C" or
"°F" LED will start to flash) and select desired
parameter
• Press the SET button to display its value. Change
7.6.3. LOCK & UNLOCK KEYBORD
• Press and hold the
than 3 seconds. "OFF" will be displayed and the
keyboard will be locked.
7.6.4. OPERATION OF CONTROL PANEL
To start the manual defrosting, press and hold the DEF
12
LIGHTS
button for at least 2
buttons for more
BUTTONS
Down
Press and release - scrolling functions; decreasing the
value of the selected parameter;
In the programming mode, the up button makes it
possible to display parameters' codes.
Set
Press and release – displays the target, requested
value of the set temperature
In the programming mode, it makes it possible to se-
lect the parameter and confirm the selected operation
Defrosting
Press and hold for min. 2 seconds
- Manual defrosting will start
will start to flash.
• To change the set value, press the
arrows.
• To store the new set value, press the SET button
again or wait 10 seconds.
the value using the
• Press SET, to store the new value and go to next
parameter. To exit: Press the
or wait 15 seconds without pressing any buttons.
CAUTION: the set value is stored even when exiting
the procedure by not pressing any buttons.
• Press and hold the
than 3 seconds, till the "on" message is displayed.
button for more than 2 seconds.
or
or
button
buttons for more