Location And Function Of Parts; Front Panel - Sony DSR-50 Mode D'emploi

Location and Function of Parts

Location and Function of Parts

Front Panel

6 OPEN switch
5 POWER switch
4 Monitor display
section (see
page 16 (GB))
4 LCD protection board
installation screw hole
(bottom of unit)
3 Carrying handle
1 Cassette lid
To open the cassette lid, slide the OPEN switch 6 to
OPEN. The lid will click open. Raise the lid and insert
a cassette.
For details of usable cassettes, see "Notes on Video
Cassettes" on page 40 (GB).
2 RESET button
Press this button (bottom of unit) to initialize the
internal clock, all menu items and the time code of the
FREE RUN setting. Press this button with the tip of a
ball-point pen or similar tool.
3 Carrying handle
Use the handle to carry the unit.
4 LCD protection board installation screw hole
Use this hole to install the LCD protection board
(supplied).
10
(GB) Chapter 1 Overview
2 RESET button (bottom of unit)
3 Audio control section (see page 15 (GB))
5 POWER switch
Push up this switch to ON to turn on the power.
Note
Power to the camera cable is not interrupted even if
this switch has been turned off. If you are not going to
use the camera, turn off the power of the camera,
disconnect the camera cable and the DSR-50/50P AC
adaptor, or remove the battery pack.
6 OPEN switch
Slide this switch to the right (OPEN) to open the
cassette lid 1.
1 Cassette lid
1 Display window
(see page 11
(GB))
2 Tape transport
control section
(see page 13
(GB))