Télécharger Imprimer la page

DeWalt DCN680 Guide D'utilisation page 14

Publicité

Les langues disponibles

Les langues disponibles

English
Fig. H
3
Headlights (Fig. I)
There is a headlight 
located on each side of the nailer.
 4 
Headlights turn on upon battery insertion, activation of
the trigger, or depressing the contact trip. The lights will
automatically shut off after 20 seconds unless tool remains
in use.
Fig. I
4
nOTE: These headlights are for lighting the immediate work
surface and are not intended to be used as flashlights.
lOW BATTERY inDiCATOR: The left-side headlight will
flash four consecutive times and then shut down to indicate
low battery.
JAMMED nAil inDiCATOR: The right-side headlight will
flash continually if a nail becomes jammed in the nosepiece
(see Clearing a Jammed Nail).
Clearing a Jammed Nail (Fig. A, J)
If a nail becomes jammed in the nosepiece, keep the tool
pointed away from you and follow these instructions
to clear:
1. Remove battery pack from tool and engage the trigger
lock-off.
2. Press the magazine latch 
loaded nails.
3. Lift the jam clear latch 
 5 
nosepiece door.
4. Remove bent nail, using pliers if necessary.
5. If driver blade is in the down position, cycle the stall
release lever 
 12 
using enough force to fully slide it to
the other end of the slot in the housings.
12
13
 16 
and remove any
then pull up to open the
6. Close the nosepiece door and engage the latch pin
under the two arms on the nosepiece. Push latch until
it locks in place.
7. Reinsert battery pack.
nOTE: The tool will disable itself and not reset until the
battery pack has been removed and reinserted.
8. Reinsert nails into magazine (see Loading the Tool).
Fig. J
5
12
nOTE: Should nails continue to jam frequently in nosepiece,
have tool serviced by an authorized D
Cold Weather Operation
When operating tools at temperatures below freezing:
1. Keep tool as warm as possible prior to use.
2. Actuate the tool 5 or 6 times into scrap lumber
before using.
Hot Weather Operation
Tool should operate normally. However, keep tool out of
direct sunlight as excessive heat can deteriorate bumpers
and other rubber parts resulting in increased maintenance.
MAINTENANCE

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
WALT service center.
e

Publicité

loading