DeWalt DCN680 Guide D'utilisation page 13

nOTE: The battery pack is not fully charged out of the
carton. Follow instructions outlined (see Charging
a Battery).
1. Read the Safety Instruction section of this manual.
2. Wear eye and ear protection.
3. Ensure magazine is empty of all fasteners.
4. Check for smooth and proper operation of contact
trip and pusher assemblies. Do not use tool if either
assembly is not functioning properly. nEVER use
a tool that has the contact trip restrained in the
actuated position.
5. Keep tool pointed away from yourself and others.
6. Insert fully charged battery pack.
Using the Trigger Lock-off (Fig. F)

WARNING: To reduce the risk of serious personal
injury, do not keep trigger depressed when tool is not
in use. Keep the trigger lock-off switch LOCKED (Fig. F)
when the tool is not in use.

WARNING: To reduce the risk of serious personal
injury, lock off trigger, disconnect battery pack
from tool and remove nails from magazine before
making adjustments.
Each D WALT nailer is equipped with a trigger lock-off
e
which when pushed to the right as shown in Figure F,
prevents the tool from firing a nail by locking the trigger and
bypassing power to the motor.
Fig. F
2
When the trigger lock-off is pressed to the left, the tool will
be fully operational. The trigger lock-off should always be
locked off whenever any adjustments are made or when
tool is not in immediate use.
NOTICE: Do not store tool with battery pack installed. To
prevent damage to the pack and to ensure best battery
life, store battery packs out of the tool or charger in a cool,
dry location.
Loading the Tool (Fig. G)

WARNING: Keep the tool pointed away from yourself
and others. Serious personal injury may result.

WARNING: Never load nails with the contact trip or
trigger activated. Personal injury may result.

WARNING: Always remove battery pack before
loading or unloading nails. Serious personal injury
may result.
1. Press magazine latch 16
magazine fully.
7
2
and open sliding
2. Insert fasteners into the side of magazine; fasteners
should be loaded with chisel tip against front
of magazine.
3. Close sliding magazine until the magazine latch
clips snuggly.
Fig. G
Unloading The Tool

WARNING: The trigger lock-off should always be
locked off whenever any adjustments are made or
when tool is not in use.
1. Press magazine latch
16
magazine 7 fully.
2. Tip the tool up until the nails slide freely out of the side
of the magazine. Close sliding magazine fully.
3. Open the jam clear door on the nosepiece to verify
there are no nails remaining.
Dryfire Lock Out feature
Tool is equipped with a dryfire lock out feature to prevent
tool from cycling when there are no fasteners loaded. When
the low nail indicator is visible, the tool is running low
17
on fasteners. If this happens, the tool will be locked out
and will not actuate until more nails are loaded. (Refer to
Loading the Tool)
Adjusting Depth (Fig. H)
The depth that the fastener is driven can be adjusted using
the depth adjustment wheel

WARNING: To reduce risk of serious injury from
accidental actuation when attempting to adjust
depth, ALWAYS:
• Remove battery pack.
• Engage trigger lock-off.
• Avoid contact with trigger during adjustments.
1. To drive the nail shallower
adjustment wheel 3 away from the nose of the nailer.
2. To sink a nail deeper
wheel 3 toward the nose of the nailer.
English
7
16
and open sliding
3 on the side of the tool.
, rotate the depth
, rotate the depth adjustment
11