EINHELL EVK 1200 Mode D'emploi page 19

Anleitung EVK 1200 mehrspr.
13. Troubleshooting guide
Fault Possible causes
Motor does not start a) No electricity in plug
b) Cable defective
c) Switch, switch/plug block
d) Connections to motor
e) Scarifier housing clogged
Engine performance drops a) Soil is too firm
b) Scarifier housing clogged
c) Cuttings severely worn
Imprecise aeration a) Cuttings worn
b) Wrong scarifying depth
Important notice!
To protect the motor itis equipped with a thermal overload switch which cuts out when overloaded and
starts again automatically after a short cooling-down period.
21.01.2004 15:26 Uhr
Rectification
a) Check line and fuse
b) Check
c) Have machine checked by
defective a customer service center
d) Have machine checked by
or capacitor disconnected a customer service center
e) Change scarifying depth if
necessary
Clean housing so that the
spike drum spins unob-
structed
a) Change scarifying depth
b) Clean housing
c) Replace spike drum
a) Replace spike drum
b) Change scarifying depth
Seite 19
GB
19