Ordering Replacement Parts; Disposal And Recycling; Troubleshooting Guide - EINHELL 34.303.50 Mode D'emploi D'origine

Anleitung_BG_KS_2440_SPK1:_
Please note: For safety reasons we recommend that
you have all sharpening and blade replacement work
carried out by a specialist workshop.
Always wear heavy duty working gloves
Undo the fastening nut (Figure 12a/Item B)
Undo the eight Philips screws (Figure 12b/Item C)
and remove the cover plate
Secure the rotary disk so that it cannot rotate (for
example by jamming it with a screwdriver, see
Figure 12c)
Undo the four blade screws (Figure 12c/Item D)
and remove the blades (Figure 12c/Item E)
Each of the blades can be turned once as they
are ground sharp on both ends. Then they must
be replaced by new blades.
To assemble, proceed in reverse order.

10. Troubleshooting guide

The machine does not a) No power at the plug
work b) Machine is switched off
c) Overload switch has tripped
d) Ejector chute is blocked
e) Loading funnel is not secure on the
motor housing
Shredding performance a) Blades worn
unsatisfactory
Shredding performance a) Blades worn
falls in quality
19.01.2012 17:39 Uhr Seite 15

8.3 Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

9. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to the
raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
a) Check the power cable and fuse
b) Switch on machine
c) Press control on overload switch
b) Clean ejector chute
e) Clean interior and tighten safety
screw
a) Turn, sharpen or replace blades
a) Turn, sharpen or replace blades
GB
15