EINHELL EVK 1200 Mode D'emploi page 18

Anleitung EVK 1200 mehrspr.
GB
9. Care and maintenance
Maintenance and cleaning work on the scarifier as
well as removal of the safety devices may only be
performed when the motor is switched off and the
power cable has been pulled.
Worn out or damaged spike drums should only be
replaced by an authorized professional (see address
on warranty certificate).
Do not clean the scarifier with running water,
particularly with high-pressure water.
Ensure that all mounting components (i.e. bolts, nuts
etc.) are always tightened so that the scarifier can be
safely operated at all times.
Store your scarifier in a dry room. In order to ensure
that you enjoy your scarifier for many years to come,
all screwed parts, as well as the wheels and axles,
should be cleaned and lubricated.
Keeping your scarifier in good condition not only
ensures a long lifespan and
high-performance, but also enables the machine to
thoroughly scarify your lawn with minimal effort. For
best results, clean the scarifier with a brush or rag.
Do not use any solvents to remove dirt.
At the end of the season, perform a general
inspection of the scarifier and remove any residues
which may have accumulated.
At the start of each season, ensure that you check
the condition of the scarifier.
If repairs are necessary, please contact one of our
customer service centers (see address on warranty
certificate).
10. Replacing the spike drum
For safety reasons, we recommend having the spike
drum replaced by an authorized professional (see
address on warranty certificate).
Important! Wear work gloves!
Only replace the unit with a genuine Einhell spike
drum (see section 11, "Ordering replacement parts"),
as this will ensure top performance and safety under
all conditions.
18
21.01.2004 15:26 Uhr
* The procedure for replacing the spike drum EMW
33, Replacement Part No.: 34.055.53, is described in
the instructions issued with EMW 33!
11. Ordering replacement parts
The following information should be given when
ordering replacement parts:
Model of machine
Art. No. of machine
ID No. of machine
Replacement part number of the required
replacement part
12. Technical data
Voltage: 230 V ~ 50 Hz
Power consumption:
Two-hand safety switch with switch/plug block
Working width:
Spike drum with stainless steel spikes
Depth adjustment:
LPA sound pressure level: 84,5 dB(A)
LWA sound power level:
Vibration on the shaft
Seite 18
1200 W
33 cm
3-fold
96 dB(A)
 2,5 m/s
2