EINHELL SPK9 Instructions D'origine page 13

The adjustment of the air and paint volumes helps
to achieve outstanding results.
The paint spray gun, with an infi nite adjustment
from wide to round jet, is ideal for both large areas
and for corners and edges.
•
Spray gun with suction-feed can (Figure 4)
Working pressure in bar: 3,5
Use the compressed-air gun (2) in combination
with the suction-feed can (6) as a paint spray gun
with suction-feed can (see Fig. 1, 5).
Range of applications:
Suitable for spraying cold cleaner, spray oil, etc.
The infi nitely variable trigger lever allows an
exact dosing of the spray material.
The rotating nozzle (c) allows you to adjust the
ratio of fl uid to the volume of air.
Tip: Before starting work, you should conduct a
small test on newspaper to fi nd the ideal settings
for achieving perfect results.
5. Before starting the equipment
5.1 Quick-release coupling
Connect
Push the nipple on your compressed air hose into
the quick-release coupling, the sleeve will auto-
matically spring forwards.
Disconnect
Pull back the sleeve and remove the hose.
Warning! As you release the hose coupling,
hold the hose coupling part in your hand to
prevent injuries caused by the hose being
thrown backwards.
The compressed air hose is also fi tted with a
quicklock coupling to which accessories can be
connected as described above.
Anl_DL_Werkzeugset_Profi_SPK9.indb 13 Anl_DL_Werkzeugset_Profi_SPK9.indb 13
GB
6. Cleaning, maintenance and
ordering of spare parts
Warning! Disconnect the air tool from the com-
pressed air source before cleaning.
Important! Do not fully immerse the tool in sol-
vent.
6.1 Cleaning
•
Clean the nozzle as well if it becomes
clogged unexpectedly or the spray pattern is
poor.
•
We recommend that you clean the appliance
immediately after you use it.
•
Clean the accessories after use with a suitab-
le cleaning agent (observe the instructions on
the working materials).
6.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
6.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
7. Disposal and recycling
The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
- 13 -
05.08.2020 10:16:47 05.08.2020 10:16:47