Machine Maintenance; Tightening Torques - Ammann AVP 1033 Mode D'emploi

5.6 Machine maintenance

5.6.1 Cleaning
The machine should be cleaned daily.
After cleaning the machine, check all cables,
hoses, pipes and unions for leaks, loose
connections, chafe marks and other damage.
Attention
Rectify any noticed defects immediately.
Do not use any flammable or aggressive materials
for cleaning purposes.

5.6.2 Tightening torques

8.8
ø
Nm ft lb
M 4 3 2
M 5 6 4
M 6 10 7
M 8 25 18
M 10 49 36
M 12 85 62
M 14 135 99
M 16 210 154
M 18 300 221
M 20 425 313
M 22 580 427
M 24 730 538
Strength classes for all bolts with untreated, non-lubricated
surfaces.
The values indicate 90% utilisation of the tesile yield strength; at
a friction coefficient of μ—- = 0.14.
Tighting torques can be verified with torque wrenches.
The specified values do not apply when using lubricant MoS2.
Renew self-locking nuts after each disassembly.
Important
5.6.3 Bolted connections
When using vibrating machines, it is important that the bolted
connections are checked for tighteness at regular intervals.
Observe tightening torques.
5.6.4 Checking rubber buffers
Check rubber buffers for cracks and other damage as well as for
tighteness and replace immediately if damaged.
10.9 12.9
Nm ft lb Nm ft lb
4,4 3 5
8,7 6 10
15 11 18
36 26 43
72 53 84
125 92 145 106
200 147 235 173
310 228 365 269
430 317 500 368
610 449 710 523
830 612 970 715
1050 774 1220 899
5.6.5 Checking and tensioning the V-belt
2
1
4
•
The remove the V-belt guard
7
•
Check the condition and tension of the V-belt (1), replace
damaged V-belts
13
•
Loosen rubber buffer fixing nuts (2)
31
•
Tension the V-belt by shifting the engine bracket (3)
61
To be noted is that the bracket (3) moves and not only
the buffers are elongated. In this case, the buffers
should be tapped forward lightly with a hammer.
Important
Deflection X: About 15 mm
•
Ensure uniform buffer tension
•
Tighten rubber buffers
•
Crank the drive manually, recheck deflection and correct if
necessary
•
Fit V-belt guard
Do not start engine without V-belt guard, risk of
injury.
Danger
•
After about 25 operating hours, recheck the V-belt tension and
retension if necessary.
31
5. Maintenance
X » 15 mm
3
2
B1033004.cdr