Safety Regulations - Ammann AVP 1033 Mode D'emploi

1. Safety regulations

This Ammann machine has been built according to the state
of the art in compliance with the pertinent rules.
Nevertheless, these machines can still constitute a hazard
to persons and property if:
•
not used for the intended purpose,
•
not operated by suitably qualified and instructed personnel,
•
modified or converted in an improper manner,
•
the pertinent safety regulations are not observed
For this reason, any person entrusted with the operation,
maintenance or repair of the machine is obliged to read and
follow the operating instructions and particulary to observe
the safety regulations. If necessary, this must be confirmed
by the signature of the company using the machine.
Furthermore, the following must be made known and
observed:
•
pertinent regulations for the prevention of accidents,
•
generally recognised safety rules,
•
country-specific regulations
Normal use
This machine is only intended for the compaction of:
sand
gravel (possibly coarse gravel)
lean concrete
asphaltic bitumen-coated gravel (medium and fine grained)
paving stones
Improper use
The machine can constitute hazards if not used by instructed
personnel or for other than the intended purpose.Not be used on
hard concrete, hardened bitouminous surfacing or frozen soil.
Who is allowed to operate the machine?
Only suitably qualified, instructed and authorised persons over
18 years of age may operate the machine. Maintenance and
repairs, particularly on the hydraulic system, require special
knowledge and must be undertaken only by qualified personnel.
Conversions and modifications to the machine
Unauthorised modifications and conversion of the machine are
not permitted for safety reasons.
Spare parts and special equipment not delivered by us are also
not approved by us. The installation and/or the use of such parts
can also have a detrimental effect on the operating safety.
The manufacturer disclaims all liability for any damage resulting
from the use of non-original parts or special equipment.
Safety information in the operating and maintenance
instructions
The following signs and designations are used in the manual to
designate instructions of particular importance.
Refers to special information on how to use the machine
most efficiently.
Important
Refers to special information and/or orders and
prohibitions directed towards preventing damage
Attention
Refers to orders and prohibitions designed to
prevent injury or extensive damage.
Danger
Information on safe and environmentally-friendly
disposal of operating and ancillary agents as well
as replacement parts.
Environment
Transporting the machine
Only load and transport the machine as specified in the operating
instructions.
Only use suitable means of transport and lifting gear with suf-
ficient bearing capacity!
Attach suitable slinging means to the points of attachment pro-
vided.
Only use sturdy loading ramps with sufficient bearing capacity.
The ramp inclination must be flatter than the gradient climbing
ability of the machine.
Secure the machine to prevent it from tilting or slipping.
It is highly dangerous to walk or stand under suspended loads.
Secure the machine on transport vehicles to prevent it from rol-
ling, slipping and tilting.
Starting the machine
Prior to starting
Familiarise yourself with the operating and control elements and
the mode of operation of the machine and the working environ-
ment. This includes, e.g. obstacles in the working area, bearing
capacity of the ground and the necessary safety provisions.
Use personal protective equipment (safety footwear, hearing
protectors, etc.).
Check to ensure that all safety devices are firmly in place.
Do not start the machine if instruments or control devices are
faulty.
Starting
For machines with handstart, only use the safety cranks tested
by the manufacturer, and precisely follow the operating
instructions of the engine manufacturer.
To crank-start diesel engines, note the correct position to the
engine and the correct hand position on the crank.
The handcrank must be turned with maximum force until the
engine starts, otherwise the crank can rebound.
Precisely follow the starting and stopping procedures specified in
the operating instructions and observe indicator lights.
Only start and operate machines with an electrical starter from
the instrument panel.
Starting and operation of the machine in potentially explosives
atmospheres is forbidden!
Starting in enclosed spaces, tunnels, mines or deep ditches
Engine exhaust fumes are highly dangerous!
20