Inventum IVW6035ASI Manuel D'utilisation page 48

Problem
The appliance stops during a
program.
The appliance makes unusual
sounds during a program.
There is food waste left on the
dishes.
There are white stains on the dishes. The amount of detergent is
48 • English
Possible cause
There is a power failure.
There is a water inlet failure.
The program is paused.
The appliance is not loaded
correctly.
One of the spray arms hits the
dishes.
The appliance is not loaded correctly
and the spray arms cannot reach all
the dishes.
The cutlery basket is too full.
The dishes are placed too close
together.
The amount of detergent is
insufficient.
The selected program is not suitable
for the loaded dishes.
One of the spray arms is clogged.
The filters are clogged.
The filters are not placed correctly.
The water drain pump is clogged.
insufficient.
The level of rinse aid consumption is
set too low.
There is a high level of water
hardness and no salt is used.
The level of water hardness is set
too low, which affects the salt
consumption.
The cap of the salt reservoir is not
closed correctly.
Possible solution
Make sure that there is power.
Make sure that there is water inlet
supply.
Start the program.
Make sure that you load the
appliance correctly. Refer to section
'Loading the appliance'
.
Make sure that you load the
appliance correctly. Refer to section
'Loading the appliance'
.
Make sure that you load the
appliance correctly. Refer to section
'Loading the appliance'
.
Make sure that you load the
appliance correctly. Refer to section
'Loading the appliance'
.
Make sure that you load the
appliance correctly. Refer to section
'Loading the appliance'
.
Make sure that you fill the detergent
reservoir with a sufficient amount of
detergent. Refer to section
the detergent reservoir'
.
Choose a suitable program. Refer to
'Programs'
section .
Clean the spray arms. Refer to
'Cleaning the spray arms'
section
Clean the filters. Refer to section
'Cleaning the filters' .
Make sure that you correctly place
the filters.
Make sure that the water drain pump
is not clogged.
Make sure that you fill the detergent
reservoir with a sufficient amount of
detergent. Refer to section
the detergent reservoir'
.
Adjust the level of rinse aid
consumption. Refer to section
'Setting the level of rinse aid
consumption'
.
Fill the salt reservoir. Refer to
'Filling the salt reservoir'
section
Adjust the level of salt consumption.
'Setting the level of
Refer to section
salt consumption' .
Make sure that the cap of the salt
reservoir is closed firmly.
'Filling
.
'Filling
.