Inventum IVW6035ASI Manuel D'utilisation page 41

3. Fill the salt reservoir. Refer to section
4. Fill the rinse aid reservoir. Refer to section
FILLING THE SALT RESERVOIR
For a good result the appliance needs soft (less calcareous) water. Salt is used to soften the water and it prevents
white lime residues on your dishes and the interior of the appliance.
Caution:
Only use salt that is suitable for a dishwasher. Do not use table salt.
Note:
Fill the salt reservoir when the salt indicator on the control panel is on.
1. Remove the lower basket.
2. Turn the cap (A) of the salt reservoir counter-clockwise to remove it.
3. Fill the salt reservoir with water.
Note:
You only have to fill the salt reservoir with water before first use of the appliance.
4. Put a funnel in the opening of the salt reservoir.
5. Fill the reservoir with salt until the overflow level.
6. Install the cap of the salt reservoir.
Caution:
Remove any spilled salt immediately and run a full program to prevent corrosion of the appliance.
SETTING THE LEVEL OF SALT CONSUMPTION
The salt consumption of the appliance depends on the level of water hardness.
Set the level of salt consumption according to the information in section
consumption)'
.
Note:
Contact your local water company to verify the level of water hardness in your area.
Note:
As a default, the level of water hardness of the appliance is set to level 3.
1. Make sure that the appliance is off.
2. Push and hold the program selector button and push the on/off button.
3. Hold the program selector button until the display briefly shows SL. After that the display shows the latest set
level of water hardness.
4. Push the program selector button to change the level of water hardness.
5. Push the on/off button to confirm the setting.
'Filling the salt reservoir'
.
'Filling the rinse aid reservoir'
.
'Water hardness level settings (salt
English
(Figure 3)
(Figure 4)
(Figure 5)
• 41