Electric Connection; Commissioning - La Pavoni EUROPICCOLA Mode D'emploi

5 – ELECTRIC CONNECTION
Warning! Before making the electric connection, make sure that the main power voltage corresponds
to the specifications indicated on the data plate placed under the base of the machine.
6 – COMMISSIONING
3
9
max
5
min
picture A
3
4
picture B
picture C
3
9
max
5
min
1
- Unscrew the cap (3) of the boiler anticlockwise,
picture A.
- Prepare a water solution with two teaspoons
of bicarbonate in a container and wait for the
bicarbonate to dissolve completely; then pour the
solution into the boiler (9).
Alternatively, instead of using bicarbonate, prepare
in a container a solution of water with a tablespoon
of white vinegar and pour it into the boiler.
- Make sure that the lever (1) is down; eventually pull
it down completely, picture C.
- Screw the cap (3) into the boiler by turning it
clockwise and make sure that the cap and the steam
tap knob (4) are properly closed (turn clockwise),
picture B.
- Fit the filter-holder (10) into the unit (11) and fix it
by moving it from right to left, picture H.
- Insert the main cable plug into an electric socket
with adequate voltage (please refer to the plate
under the base of the machine), picture C.
- Place the switch (6) on the ON position and wait
for the machine to reach the required pressure
(about 5 minutes), place a container under the unit
(11), slowly lift the lever (1) completely and hold
it in this position so as to fully discharge the water
contained in the boiler. Subsequently switch the
machine off and remove the plug from the power
socket, open the steam tap knob (4) anticlockwise
and wait until all the steam has been discharged
from the steam pipe (12) provided, open the boiler
cap (3) anticlockwise and turn the machine upside-
down to eliminate all the remaining water from the
boiler. Fill the boiler again with fresh water and
use it to rinse of the machine inside to eliminate any
residues of the solution.
33
English