La Pavoni EUROPICCOLA Mode D'emploi page 38

English
10 – MAKING CAPPUCCINO WITH THE AUTOMATIC CAPPUCCINO MAKER
18
foto N
FIG 2
- place the cup containing the previously prepared coffee under the nozzle of the Cappuccino Automatic,
and open the steam tap knob (4) by turning it anticlockwise; this will start the delivery of emulsified hot
milk, with abundant froth. To stop the delivery, close the steam tap knob (4), by turning it clockwise.
You can adjust the milk froth by acting on the pin (C) (Fig. 2), Cappuccino Automatic to have the desired
consistency of cream. For a cream with greater volume, move the plug upwards (Fig. 2).
When you are done making cappuccino you must clean milk residues from the Automatic Cappuccino
maker.
1. put beside the machine a full glass of water, and dip the suction pipe (B) .
2. Proceed as for the normal preparation of a cappuccino, letting the dirty water in unrecipiente suitable.
The cappuccino can also be prepared by using the steam pipe (12).
To obtain the milk froth for the cappuccino, pour the milk to be prepared in a tall and narrow container
The replacement of the traditional steam pipe (12) with the
Cappuccino Automatic (17) (an optional part on the models with
black base) must take place before starting the machine.
The operations to be carried out are the following:
19
- Make sure that the steam tap knob (4) is closed, (picture B);
- Turn the steam pipe (12) clockwise until it stops and slip the steam
20
pipe out of its seat, pulling it rightwards, (picture N);
17
- Slide the Automatic Cappuccino maker onto the steam pipe (18)
up to the stop and tighten the locking ring (clockwise) (Fig. 2).
- Slip in its seat the device with the Cappuccino Automatic (17),
pushing it leftwards, (Fig. 2). Turn the device with the Cappuccino
Automatic (17) anticlockwise until it stops. replacement of the
traditional steam pipe (12) with the Cappuccino Automatic (17)
(an optional part on the models with black base) must take place
before starting the machine.
The operations to be carried out are the following:
- Make sure that the steam tap knob (4) is closed, picture B.
- Turn the steam pipe (12) clockwise until it stops and slip the steam
pipe out of its seat, pulling it rightwards, picture N.
- Slip in its seat the device with the Cappuccino Automatic (17),
pushing it leftwards, picture O. Turn the device with the Cappuccino
Automatic (17) anticlockwise until it stops.
Cappuccino Preparation
Once the machine has reached the required pressure, as illustrated
in chapter 7 - STARTING THE MACHINE, proceed as follows:
- insert the silicon tube (20) in the milk container, placed next to
the machine, (picture P);
38