Technical Specification - iKarus Lama Manuel D'utilisation

- Never drop the charger nor hit it.
- Never puncture a Li-Ion or Li-Poly battery.
- Always check for correct polarity when connecting the battery. Other-
wise the battery will be damaged or destroyed. It may catch fire or even
explode!
- Never charge more than one battery at a time. Otherwise the batteries
will be damaged or destroyed. They may catch fire or even explode!
- Always discard batteries according to the local regulation. Do not discard
batteries with your household garbage.
- If you deep discharge the battery it will be destroyed. As soon as you
realize a power loss during flight, immediately land the helicopter and
disconnect the battery. Never try to keep the helicopter flying until the
motors stop running!
Monitoring the charge process:
- First plug the Power Adapter to the wall outlet. Now connect the charger
via its power jack to the 15V ... 18V power source. The Power LED will
light up red, the Charge LED green.
- When charging a 2-cell (7.4V) Li-Ion or Li-Po battery, plug the special
battery connector into the charge jack for 2-cell (7.4V) batteries. The
Charge LED will flash red indicating that the battery charger is in charge
mode. As soon as the battery is fully charged the LED will turn green.
- When charging a 3-cell (11.1V) Li-Ion or Li-Po battery, plug the special
battery connector into the charge jack for 3-cell (11.1V) batteries. The
Charge LED will flash red indicating that the battery charger is in charge
mode. As soon as the battery is fully charged the LED will turn green.
Pay attention to the connecting sequence – first wall plug, than charger, than
battery – otherwise you will destroy the charger.
ATTENTION: Use the wall plug unit only in conjunction with the charger. Never
attempt to charge any other components or R/C radios with it.
Technical
Specification: Output current:
Input current:
Output voltage:
2 cells 7.4V charge jack :
3 cells 11.1V charge jack:
26
750 mA
15V – 18V 1000 mA DC
8,4V
12,6V