iKarus Lama Manuel D'utilisation page 29

- Next swap the leads of the two gimbal stick units. Left inner lead onto
right inner connector, left outer lead onto right outer connetor and visa
versa. (siehe Kapitel „Die verschiedenen Modi")
- Be careful when pulling the connector off the circuit board in the
transmitter rear cover so that no leads get pulled out of the connectors.
Always pull on the connector housing, NOT on the leads.
- Screw transmitter rear cover back on.
- Change the setting of the reverse switches (DIP Switches) 1 and 2 on
the back of the transmitter (Pict. 3) to correct the directional operation of
the servos. Definitely check before your first flight, that the servo
direction is actually correct.
Pict. 1
Install
ratchet
Remove
neutralizing
lever
Remove
spring
Servo reverser switch:
You can reverse the servo operation
direction with the help of the switches
on the back of the transmitter. This has
the advantage that you do not have
to pay attention to the servo direction
during installation into the model. The
servo reverse switches are assigned as
following (switches 5 – 8 are inherent):
Install
spring
Install
neutralizing
lever
Remove
ratchet
4
Pict. 3
29
Pict. 2: Neutralizing
lever
3
1
ON DIP
1 2 3 4 5 6 7 8
2