Changing The Transmitter Mode - iKarus Lama Manuel D'utilisation

Follow the checking procedure below to assure a safe flight:
Place the helicopter on a flat and dust free surface. Fully extend the transmit-
ter antenna. The throttle stick should be in idle position (left stick towards you).
Switch on the transmitter. As soon as you connect the flight battery connector
with the receiver the LED will flash fast, indicating that the system is ready.
The incorporated gyro will calibrate itself and the helicopter is ready for opera-
tion.
Important: Always switch on the transmitter first and than connect the flight
battery in the helicopter. After the flight, disconnect first the flight battery and
than switch off the transmitter. If you do not follow this sequence, the model
may start up inadvertently and may get damaged and/or cause damage.
When moving the left control stick on the transmitter forward both motors will
start and the helicopter will lift off. If you move this stick to the right, the helicop-
ter will turn to the right around the vertical axis. Move the right stick forward, the
swash plate will tilt forward, the helicopter will lower its front (if in flight) and will
fly forward. Moving the right stick to the right, the swash plate will tilt to the right
and the helicopter will start a right turn.
The trim sliders will assist you in preventing the drifting of the helicopter.

Changing the Transmitter Mode

For example:
- First remove the transmitter crystal and the battery box.
- Unscrew the back of the transmitter.
- Look at Pict. 1 and unhook the spring on the left gimbal stick unit.
- For easier removal of the neutralizing lever (Pict. 2) loosen the four
screws of the left gimbal stick unit a little.
- Remove the neutralizing lever and tighten the four screws again.
- Remove ratched from right unit (viewed as shown in above Pict. 1).
Install the neutralizing lever (shown in Pict. 5) as well as the spring on
the right unit. This gimbal stick is now self neutralizing.
- Install the ratchet on the left unit at the location shown in Picture 1.
change from Mode 2 (standard) to Mode 3 (right stick eleva-
tor and rudder, left stick forward/backward pitch and roll)
28