ZANKER KBB24001SK Notice D'utilisation page 24

Remove the lower door.
Loosen the lower pin.
Ventilation requirements
The airflow behind the
appliance must be suffi-
cient.
Installing the appliance
Caution! Make sure that the mains cable can
move freely.
Do the following steps:
24
On the opposite side:
Install the lower pin.
Install the lower door.
Install the upper door.
Tighten the spacer and
the upper pin.
5 cm
min. 200cm
min.
200cm
x
1
If necessary cut the
adhesive sealing strip
and then apply it to the
appliance as shown in
figure.
2
2
4mm
44mm
3
Adjust the appliance
in the niche.
Make sure that the dis-
tance between the appli-
ance and the cupboard
front-edge is 44 mm.
The lower hinge cover (in
the accessories bag)
makes sure that the dis-
tance between the appli-
ance and the kitchen fur-
niture is correct.
Make sure that the clear-
ance between the appli-
ance and the cupboard is
4 mm.
Open the door. Put the
lower hinge cover in posi-
tion.
x
2
Install the appliance
in the niche.
Push the appliance in the
direction of the arrows (1)
until the upper gap cover
stops against the kitchen
furniture.
Push the appliance in the
direction of the arrows (2)
against the cupboard on
the opposite side of the
hinge.
I
I
4
Attach the appliance
to the niche with 4
screws.
2
1