ZANKER KBB24001SK Notice D'utilisation page 21

calling a technician out. In the following chart informa-
tion is given about them to avoid unnecessary charges
on service.
Important! The operation of the appliance goes with
certain sounds (compressor and circulating sound).
This not means a trouble, but a normal operation.
Problem
The compressor operates
continually
Water flows at the back plate
of the refrigerator
Water flows into the refrigera-
tor compartment
Water flows onto the floor
The lamp does not work.
It is too warm in the refrigera-
tor
It is too cold in the refrigera-
tor
Possible cause
The Temperature Regulator may be
set incorrectly
The door does not close tightly or it
is not shut properly
The door has been opened too fre-
quently
Food placed in the appliance was
too warm
The temperature of the room that
contains the appliance is too high for
efficient operation
During automatic defrosting, frost
melts on the back plate
The outlet can be clogged up
Products placed in can prevent water
from flowing into the collector
The melting water outlet flows not in-
to the evaporative tray above the
compressor
The lamp is in stand-by.
The lamp is defective.
The Temperature Regulator may be
set incorrectly
The door does not close tightly or it
is not shut properly
Food placed in the appliance was
too warm
Large quantities of food to be cooled
were put in at the same time
There is no inside cool air circulation
The Temperature Regulator may be
set incorrectly
Important! The appliance operates discontinuously, so
the stopping of compressor does not mean being no
current. That is why you must not touch the electrical
parts of the appliance before breaking the circuit.
Set a warmer temperature
Check if the doors close well and the
gaskets are undamaged and clean
Do not leave the door open longer
than necessary
Allow food to cool to room temperature
before storing
Try to reduce the temperature in the
room where the appliance stands
It is normal
Clean the outlet
Replace the products so that they can
not touch the back plate directly
Put the melting water outlet to the
evaporative tray
Close and open the door.
Refer to "Replacing the lamp".
Set a lower temperature
Check if the door closes well and the
gasket is undamaged and clean
Allow food to cool to room temperature
before storing
Insert smaller quantities of food to be
cooled at any one time
Provide inside cool air circulation
Set a higher temperature
Solution
21