Parking, Transport And Storage; Maintenance - Miele SDAE0 Mode D'emploi

en-US

When vacuuming, in particular
fine dust, e.g. dust, sand, plaster,
flour, etc., electrostatic charges build
up naturally. Under certain conditions
these charges will be released. To
avoid the unpleasant effects of these
discharges, a metal inlay has been
incorporated into the underside of
the handle. Please make sure that
you keep your hand in constant con-
tact with this metal strip during vacu-
uming (Fig. 23 + 24).

Parking, transport and storage

Park system for pauses during vacu-
uming (Fig. 25)
(cannot be used with the Electrobrush
SEB 228)
The park system allows you to conve-
niently park the suction wand and floor-
head during pauses.
 Slot the floorhead into the parking at-
tachment on the vacuum cleaner.
If your vacuum cleaner is on a slop-
ing surface, e.g., a ramp, retract the
telescopic suction wand fully.
Park system for storage (Fig. 26)

Always disconnect the vacuum
cleaner from the power supply when
you have finished using it. Remove
the plug from the socket.
 Stand the vacuum cleaner upright.
It is a good idea to retract the tele-
scopic suction wand fully.
18
 Slot the floorhead downwards into
one of the parking attachments on ei-
ther side of the vacuum cleaner.
This makes the vacuum cleaner easier
to carry or store.
If your vacuum cleaner has an XXL han-
dle, you can detach this so that the
vacuum cleaner requires less storage
space (Fig. 27).
 Detach the XXL handle from the re-
tracted telescopic suction wand.
 Wind the suction hose around the
telescopic suction wand and then slot
the XXL handle into the second park-
ing attachment.

Maintenance


Always switch off the vacuum
cleaner for maintenance work and
remove the plug from the outlet.
The Miele filtration system consists of
three components:
– Original Miele FilterBag
– Motor protection filter
– Original Miele exhaust filter
These will need to be replaced from
time to time to ensure that your vacuum
cleaner performs efficiently.