Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
en-US
Replacing one type of exhaust filter
with another (Fig. 08)
Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters :
a AirClean
b Active AirClean 50 (black)
c HEPA AirClean 50 (white)
Do not use more than one exhaust fil-
ter at a time.
When changing the filter, please note:
1. If you wish to replace exhaust filter a
with filter b or c, it is essential that
you remove the filter frame before
you fit the new exhaust filter.
In addition, you must activate the ex-
haust filter change indicator (Fig. 11).
2. If you wish to replace exhaust filter b
or c instead of a, so it is essential
that you also fit it in a filter frame *
(Fig. 32).
* Filter frame - see "Optional acces-
sories."
When to change the thread catchers?
(only possible for models with a re-
versible floorhead included as standard)
The thread catchers on the suction inlet
of the reversible floorhead can be re-
placed. Check them from time to time
and replace them if the pile has worn
down.
How to replace the thread lifters
(Fig. 36)
Use a suitable screwdriver to remove
the thread lifters from the slots.
22
Install new thread lifters.
Cleaning the roller on the AllTeQ
floorhead (Fig. 37)
Clean the roller on the floorhead if re-
quired.
Release the bearing using a coin.
Press the bearing out, and remove.
Remove the roller.
Remove any threads and hair, replace
the roller and refit the bearing, locking
it back into position.
Replacement parts are available from
your Miele dealer or through Miele
Technical Service.
Publicité
Chapitres
Table des Matières
