Installation - Hach TitraLab AT1000 Série Manuel D'utilisation De Base

Figure 4 Contents of the application box
1 Beakers (10 x 50 mL and 10 x 150 mL)
2 Tube with anti-diffusion tip
3 Conical adapters (2x)
4 Magnetic stir bars (10x)
5 Legacy sensor adapter
4
6 Sensor

Installation

Multiple hazards. Only qualified personnel must conduct the tasks described in this section of the
document.
The instrument is available in different configurations (refer to
supplies instructions for the installation of an instrument with one syringe and one pump. Adjust the
installation procedure as applicable to accommodate the number of syringes and pumps in the
instrument.
Installation guidelines
• This instrument is for indoor use only.
• The power supply connector on the rear panel must be easily accessible so the power can be
disconnected quickly in case of emergency.
• Keep the instrument away from temperature extremes, including heaters, direct sunlight and other
heat sources.
5
1 for each syringe
2
If necessary for the application
6
Not in all application kits
3
Not in all application kits
4
Type and quantity depends on application
8 English
2
3
C A U T I O N
5
7 Syringe holding ring
8 Syringe (refer to Table 1
9 USB applications key
6
10 Glass bottles
11 Bottle caps (2 x GL45 and 1 x GL25)
12 Empty desiccant cartridges (3x)
Table 1 on page 6). This manual
on page 6 for quantity)