References To Illustrations; Preparing For Use - Miele Swing H1 Mode D'emploi

References to illustrations

The illustrations referred to in the text
are shown on the fold-out pages at
the end of these Operating Instruc-
tions.

Preparing for use

Attach the suction wand (Fig. 01)
 Fit the suction wand with the square
hole facing upwards into the body of
the vacuum cleaner and twist gently
until it clicks into place.
To detach the suction wand
 Press the release button (see detail)
and pull off the wand from the vac-
uum cleaner housing with a gentle
twist.
Connecting the handle to the wand
(Fig. 02)
 Fit the handle with the square hole
facing upwards into the wand and
twist gently until it clicks into position.
 To release the handle from the wand,
press the release button and pull the
handle out of the wand, twisting it
slightly as you do so.
The handle can also be fitted directly to
the body of the vacuum cleaner (Fig.
03).
The vacuum cleaner is then easier to
use, e.g., when vacuuming mattresses,
upholstery, etc.
Fitting the floorhead (Fig. 04)
 Attach the floorhead to the vacuum
cleaner connection stub and twist
gently until it clicks into position.
 To remove the floorhead, press the
release button and pull the vacuum
cleaner away from the floorhead
twisting it slightly as you do so.
The suction wand can also be attached
to the vacuum cleaner connection stub
(Fig. 05). This is useful for vacuuming
underneath low furniture, for example.
Winding up the power cord (Fig. 06)
When the vacuum cleaner is not in use,
the power cord can be wound around
the two cord hooks.
Secure the power cord by clipping the
plug to the cord (see detailed image).
Using the accessories supplied
(Fig. 07)

Accessory clip

Crevice nozzle

Upholstery nozzle
Accessory clip (Fig. 08)
(as standard depending on model)
 If required, attach the accessory clip
to the suction wand.
 Push the accessory clip down over
the cable hook ring until it clicks into
position.
The accessory clip holds the acces-
sories (Fig. 09).
Some models are supplied as standard
with one of the following accessories
which are not illustrated.
– Electrobrush
– Turbobrush
en-US
13