Ammann ATR 30 Traduction Du Mode D'emploi Original page 39

5. Op tional equip ment
Base plate B=100 mm / 3.94 in
Base plate B=200 mm / 7.87 in
Base plate B=375 mm / 14.76 in
6. Noise and vi bra tion data
The fol low ing noise and vi bra tion data ac cord ing to EC Ma chin ery Di rec tive in the ver sion (2006/42/EC), was de ter mined, tak ing into ac count the
fol low ing stan dards and di rec tives. In op er a tional use, val ues can de vi ate de pend ing on the pre vail ing con di tions.
1)
6.1 Noise data
The noise data spec i fied in Ap pen dix 1, sub-clause 1.7.4.u of the EC Ma chin ery Di rec tive is for:
Sound pres sure level at the work place L
Mea sured sound power level L
Guar an teed sound power level L
The noise val ues were de ter mined, tak ing into ac count the fol low ing di rec tives and stan dards:
Di rec ti ve 2000/14/EC / EN ISO 3744 / EN 500-4
6.2 Vi bra tion data
Hand/arm vi bra tion val ues ac cord ing to Ap pen dix 1, sub-clause 3.6.3.1 of the EC Ma chin ery Di rec tive:
To tal vi bra tion value of the
ac cel er a tion a
hv
Un cer tain ty K
The ac cel er a tion value was de ter mined, tak ing into ac count the fol low ing di rec tives and stan dards:
EN 500-4 / DIN EN ISO 5349
1)
As the per mis si ble rat ing sound level of 85 dB (A) can be ex ceeded by this ma chine, op er a tors must wear hear ing pro tec tors.
PA
WA,m
WA,g
Op ti on
Op ti on
Op ti on
94 dB
101 dB
103 dB
2
8.5 m/s / 27.89 ft/s
2
1.0 m/s / 3.28 ft/s
33
2. Tech ni cal da ta
2
2