Hanging The Device - Medion LIFE E66566 Notice D'utilisation

34)
FUNC
35) Timer
36)
Prog MEM
37)
38)
Vol -
39)

6. Hanging the device

The under cabinet radio is designed to be mounted on the underside of a wall
cupboard or shelf unit. You will need 4 screws to mount the device. The size and
length of the screws must match the mounting plate and bracket.
If the doors of your wall cupboard do not close flush with the carcase, you will also
need the spacers supplied for assembly so that you can open the cupboard door
without any problems. You can also temporarily position the radio under your wall
cupboard with the mounting plate pushed in and check that the front panel is not
covered.
 Check that the marked position is correct using the device.
 If necessary, drill four holes (diameter approx. 1 mm) where you made your
markings with a 1.5 mm drill bit on the underside of the shelf unit.
The screws supplied are suitable for mounting on wooden subsurfaces.
Appropriate screws must be used for other materials. When mounting
on wooden subsurfaces, pre-drilling is usually not required.
56
Switch between operating modes (radio/CD/AUX)
In radio mode: user selection (switch between station
memory groups A and B)
Select cooking timer memory slot (T1–T6)
Create programmed CD playback;
save individual timer time
In CD mode:
Short press: skip back to the start of the track that is
currently being played;
Press 2x: play previous track;
Press and hold: rewind within a track
In radio mode:
Short press: station memory slot back, previous frequency,
Press and hold: station search
Decrease volume;
select descending value during a selection
Switch device on/switch to standby mode
backwards
 Select a space close to a mains
power socket.
 Hold the mounting plate in the
desired position and mark the four
drill holes.