Ryobi RBC1226I Traduction Des Instructions Originales page 7

authorised service centre.
BRUSHCUTTER SAFETY WARNINGS
■
In addition to the above rules, these
additional instructions are appropriate
when using the product in brushcutter
mode.
■
Use heavy-duty gloves while installing or
removing blades, they have sharp edges.
■
Do not attempt to touch or stop the blade
when it is rotating.
■
A moving blade can cause severe injury.
Maintain proper control of the machine with
both hands until the blade has completely
stopped rotating.
■
Replace any blade that has been damaged.
Always make sure blade is installed
correctly and securely fastened before
each use.
■
Use only the manufacturer's replacement
Tri-Arc blade. Do not use any other cutting
attachment.
■
Never cut any material over 13 mm
diameter.
■
Your brushcutter is fitted with a harness.
Carefully adjust
comfortably and help to support the weight
of the machine at your right side.
■
Identify the Quick Release mechanism
and practice using it before you start using
the product. Its correct use may prevent
serious injury in case of an emergency.
Never wear additional clothing over the
harness or otherwise that restrict access to
the quick release mechanism.
■
Cover the blade with the blade protector
before storing the
transportation. Always remove the blade
protector before using the unit. If not
removed, the blade protector could become
a thrown object as the blade begins to turn.
■
Exercise extreme caution when using the
blade with this product. Blade thrust is the
reaction that may occur when the spinning
blade contacts anything it cannot cut. This
contact may cause the blade to stop for an
instant, and suddenly "thrust" the unit away
the harness to fit
unit, or during
from the object that was hit. This reaction
can be violent enough to cause the
operator to lose control of the unit. Blade
thrust may occur without warning if the
blade snags, stalls, or binds. This is more
likely to occur in areas where it is difficult to
see the material being cut.
■
For cutting ease and safety, approach the
weeds being cut from the right to the left.
In the event that an unexpected object or
woody stock is encountered, this practice
could minimize the blade thrust reaction.
Both hands must be used at all times to
control this product.
TRANSPORTATION AND STORAGE
■
Stop the product and allow it to cool before
storing or transporting.
■
Clean all foreign materials from the product.
If a cutting blade is fitted, cover it with the
blade protector.
■
If a cutting blade is fitted, cover it with the
blade protector.
■
For storage, always disconnect from power
supply and wind the cable. Store it in a
cool, dry and well-ventilated place that
is inaccessible to children. Keep away
from corrosive agents, such as garden
chemicals and de-icing salts. Do not store
outdoors.
■
For transportation, secure the product
against movement or falling to prevent
injury to persons or damage to the product.
MAINTENANCE
WARNING
Use only original
replacement parts,
attachments. Failure to do so can cause
possible injury, poor performance, and may
void your warranty.
WARNING
Servicing requires
knowledge and should be performed
only be a qualifi ed service technician. For
service, we suggest you bring the product
to your nearest authorised service centre for
repair. When servicing, use only identical
replacement parts.
manufacturer's
accessories, and
extreme care and
English | 5
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK