Combustible Material Round The Fireplace; Preparation; Assembly Of The Flue Callor - Dovre 2100 Série Installation Et Mode D'emploi

3.1.4. Combustible material round the fireplace

Within the radiation area of the fireplace
Assure a distance of at least 80 cm between the opening of the fireplace and com-
bustible material. That distance may be reduced to 40 cm if the combustible materi-
al is sufficiently shielded and well ventilated.
Outside the radiation area of the fireplace
Assure a distance of at least 5 cm between the mantle built
around the fireplace and combustible material. A small
surface contact between combustible material and the man-
tle (e.g. wall cladding) is allowed if the mantle of the fire-
place is sufficiently insulated.
A wooden ornamental rafter must not be installed within
the radiation area of the fire. Outside the radiation area,
there must always be a ventilation gap of 1 cm all around to
prevent heat from building up (see picture).
No combustible material must be present within 50 cm from the convection outlet
areas.
3.2.

Preparation

Please inspect the fireplace for damage caused during transport immediately after
delivery and notify your distributor in case there are any defects. Do not put the
appliance into operation in the meantime.
In order to avoid damaging the fireplace during installation and to make its handling
easier, it is recommended to remove previously all loose parts (fire-resistant bricks,
grille, ashtray, ...) from the stove. Note the location of those parts while removing
them, so that you have no difficulties in re-assembling the parts later on.
The stove will be supplied with the following parts:

A flue collar with fixing material

A "cold handle" to open the door

A "cold handle" to remove the ashtray
3.2.1. Assembly of the flue Collar
Fix the flue collar on the smoke dome with bolts,
nuts and collars. Assure proper sealing with kit or
paste.
2100
34
min 1 cm
min 1 cm
03.27855.100