Installation; Plug Installation; Unpacking And Testing The Appliance; Locating The Fireplace - Dovre VIRTUS E50 Installation Et Mode D'emploi

automatically, since a fire risk exists if the
heater is covered or positioned incorrectly.
Disconnect all power supply before cleaning,
maintenance or relocation of the fireplace.
Keep the heater clean. Do not allow any
objects to enter any ventilation or exhaust open-
ing as this may cause electric shock, fire or
damage to the heater.
Do not immerse the cord, plug or any part of
the appliance in water or any other liquid.
In order to avoid a hazard due to inadvertent
resetting of the thermal cut-out, this appliance
must not be supplied through an external
switching device.
CAUTION: Procedures and techniques,
which, if not carefully followed, will result in
damage to the equipment.
WARNING: Procedures and techniques,
which, if not carefully followed, will expose the
user to the risk of fire, serious injury, illness or
death.

Installation

Plug installation

Your power cord will come separate from the unit,
please locate it when unpacking your fireplace. The
plug contained inside the box is predetermined at the
factory and according to orders placed by authorized
dealers.
Available are UK, European, Swiss & Australian
plugs. Should you require any of these options please
contact your dealer for purchase. You will be required
to give them the correct part number as listed below.
Please following the instructions to correctly install
the plug into your fireplace.
1. Included in the box will be a power cord similar to
the one pictured below. See Picture 1.
Subject to change because of technical improvements
Picture 1
2. Hold the male plug and insert it into the female
receptacle. The receptacle is located on the right
side of the fireplace
3. Please make sure the plugs are firmly connected.
See Picture 2 above.
Unpacking and testing the
appliance
Carefully remove the appliance from the box.
Prior to installing the appliance, test to make sure the
appliance operates properly by plugging the power sup-
ply cord into a conveniently located 240 Volt grounded
outlet.
Test all aspects of its operation (manual switches,
remote and heater) to make sure all components oper-
ate correctly.

Locating the fireplace

Plan where to locate and frame the fireplace. Consider
the following:
1. Consider a location where the fireplace screen will
not be exposed to direct sunlight from windows or
doors.
09-20022-070
2. A 15 ampere, 240 Volt, 50 Hz branch circuit with
proper ground must be available at the location.
Preferably a dedicated branch circuit should be
provided to avoid circuit breakers to trip of fuses to
blow.
09-20022-071
Picture 2
09-20022-072
D OVRE
5