Dovre VIRTUS E50 Installation Et Mode D'emploi page 22

.
Press it again and the flame and the charcoal bed
turn on, the LCD screen displays
The buzzer beeps once when the key is pressed.
Press to adjust the red flame.
The buzzer beeps once when the key is pressed.
Press to adjust the yellow flame.
The buzzer beeps once when the key is pressed.
Press to adjust the blue flame.
The buzzer beeps once when the key is pressed.
Press to turn on, turn off and adjust top light col-
ors. The buzzer beeps once when the key is pressed.
Press the heating key
Press for the first time, the heating elements work
at 1900W, the LCD screen displays
ator on the machine lights red.
Press a second time, the heating elements work at
950W, the LCD screen displays
on the machine lights blue.
Press a third time and the heating elements turn
off, the LCD screen does not display the function
icon, the indicator
buzzer beeps once when the key is pressed.
D OVRE
8
.
.
the indic-
, the indicator
on the machine goes off. The
Note: in case the heating elements are turned
on by remote control, whether the heating ele-
ments work or not depends on the temperature
setting and ambient temperature. They work
only when the temperature setting is above the
ambient temperature.
Press keys or to adjust the temperature set-
ting between 7°C and 30°C .The buzzer beeps when
the key is pressed.
Press shift key .
Press once, the corresponding figure flashes.
Press now to set current time and week.
The buzzer does not beep when the key is
pressed.
Press timing parameter setting key
Press for the first time and the LCD screen dis-
plays to indicate Monday. Now the tem-
perature setting flashes, press
timing temperature for Monday, press key
confirm and then press
timing. The displayed time parameter is "00-23."
Press to set the current operating state of tim-
ing function.
indicates that the timing is on currently and the
control temperature is the temperature setting
indicates that the timing is on currently and the
control temperature is the temperature setting
minus 3°C, No display indicates timing is off cur-
rent and the heating elements do not work. Cor-
responding point flashes when setting.
Subject to change because of technical improvements
.
to set the
to
the time setting for