Test Run; Changing The Thrust Direction - Vetus BOW PRO Série Instructions D'installation

7

Test run

Consult the instructions in the owner's manual in '3 Operation' to en-
gage and operate the bow thruster.
Do not test the bow thruster when the boat is out of the water
unless you are convinced that everyone is at a safe distance
from the propeller tunnel .
If, during the test run, it appears that the movement of the boat is
contrary to the direction in which the joystick is moved, reconfigure
as follows.
The illustrated operations must be performed on EACH panel in-
stalled .
7 .1

Changing the thrust direction

1
Place the panel in configuration mode.
N.B. The panel must be in the OFF position (if the panel is NOT in the
OFF position, first press the On / Off button once to switch the panel
to the OFF position.
• Press and hold the On / Off button for 10 seconds.
During the first 6 seconds, the buzzer will continuously signal a didi-
didididi ..... (. . . .). Keep pressing the On / Off button. After 10 seconds
the buzzer sounds the signal dididididah (. . . - -). Now the panel is in
configuration mode.
2
3
2 x
BLUE and RED,
simultaneously
didahdi ( . − . )
The settings of the thrust direction have been changed and will
remain as set even when the voltage supply has been switched off .
32
020805.01
W
arninG
4
RED
GREEN
ashing
10 seconds
GREEN
1 x
RED
1 x
vetus® Installation instructions BOW PRO Series Thrusters: BOWA0572
6 seconds
dididididididid ( . . . . . . )
3 seconds
dididididah ( . . . . − )
Con guration mode
5
1 x