Connecting Main Power Cables - Vetus BOW PRO Série Instructions D'installation

Main power fuse 2
In the connection unit, there is a main power fuse on the controller.
This fuse must be in place at all times .
When replacing the fuse, the replacement must be of the same rat-
ing .
5 .5

Connecting main power cables

Make sure that no other electrical parts come loose when con-
necting the electric cables .
Check all electrical connections after 14 days . Electrical parts
(such as bolts and nuts) may come loose as a result of fluctua-
tions in temperature .
• Take off the cover.
• Feed the battery cables through the input glands in the cover.
• Apply cable terminals to the battery cables and connect the ca-
bles to the motor controller.
The tightening torque of bolts in the motor regulator is a
maximum of 16 Nm .
The drawing shows how the cables must be laid in order for the
cover to be replaced again.
See Chapter 6 Configuring the system before replacing the
cover again
• Reinstall the cover and tighten the glands.
vetus® Installation instructions BOW PRO Series Thrusters: BOWA0572
n
ote
n
ote
n
ote
Make sure that the voltage stated on the motor type plate is iden-
tical to the boat's power supply voltage .
Fuse
Main switch
ENGLISH
n
ote
14 - 16 Nm
29
020805.01