Troubleshooting - ZANKER KDI10001XK Notice D'utilisation

Cleaning the filters
1
3
5
7

Troubleshooting

The appliance does not start or it stops during opera-
tion.
Before you contact the Service, refer to the informa-
tion that follows for a solution to the problem.
20
C
B
A
2
4
D
6
8
To remove filters (B) and (C), turn the handle counter-
clockwise and remove. Pull apart filter (B) and (C).
Wash the filters with water.
Remove filter (A). Wash the filter with water.
Before you put the filter (A) back, make sure that there
are no residues of food or soil in or around the edge of
the sump.
Make sure that filter (A) is correctly positioned under
the 2 guides (D).
Assemble filters (B) and (C). Put them back in filter
(A). Turn the handle clockwise until it locks.
An incorrect position of the filters can cause bad
washing results and damage to the appliance.
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged, remove re-
maining parts of soil with a thin pointed object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use abrasive
products, abrasive cleaning pads or solvents.
Internal cleaning
If you regularly use short duration programmes, these
can leave deposits of grease and limescale inside the
appliance.
To prevent this, we recommend to run long duration
programmes at least 2 times per month.
With some problems, different indicators flash
continuously or intermittently at the same time to
show an alarm code.