ZANKER KDI10001XK Notice D'utilisation page 18

A
B
3
Put the detergent or the tablet in compartment (A) If
the programme has a prewash phase, put a small
quantity of detergent in compartment (B).
Using the combi detergent tablets
When you use tablets, that contain salt and rinse aid,
do not fill the salt container and the rinse aid dispens-
er. The rinse aid indicator always comes on if the rinse
aid dispenser is empty.
1. Adjust the water softener to the lowest level.
2. Set the rinse aid dispenser to the lowest position.
If you stop to use the combi detergent tablets,
before you start to use separately detergent, rinse
aid and dishwasher salt, do these steps:
1. Set the water softener to the highest level.
2. Make sure that the salt container and the rinse aid
dispenser are full.
3. Start the shortest programme with a rinsing
phase, without detergent and without dishes.
4. Adjust the water softener to the water hardness in
your area.
5. Adjust the released quantity of rinse aid.
Setting and starting a programme
Setting mode
The appliance must be in setting mode to start a
programme.
Turn the programme knob until the programme marker
is aligned with a programme on the control panel. If
the on/off indicator comes on and the start indicator
starts to flash the appliance is in setting mode.
If the control panel does not show this condition, press
and hold the start button until the appliance is in set-
ting mode
18
4
Starting a programme
1. Open the water tap.
2. Close the appliance door.
3. Turn the knob until the programme marker is
aligned with the symbol of the programme you
want to set.
• The on/off indicator comes on.
• The start indicator starts to flash.
4. Press the start button to start the programme.
• The on/off indicator and the start indicator are
on.
• The washing phase indicator comes on.
Opening the door while the appliance operates
If you open the door, the appliance stops. When you
close the door, the appliance continues from the point
of interruption.
Cancelling the programme
1. Press and hold the start button until the start indi-
cator starts to flash.
Make sure that there is detergent in the deter-
gent dispenser before you start a new pro-
gramme.
At the end of the programme
When the programme is completed
you do not deactivate the appliance within 5 minutes
all indicators goes off. This helps to decrease energy
consumption.
1. To deactivate the appliance, turn the knob until
the programme marker is aligned with the on/off
indicator.
2. Close the water tap.
Important
• Let the dishes become cold before you remove
them from the appliance. Hot dishes can be easily
damaged.
• First remove the items from the lower basket, then
from the upper basket.
• There can be water on the sides and on the door of
the appliance. Stainless steel becomes cool more
quickly than the dishes.
comes on. If