ZANKER KDI10001XK Notice D'utilisation page 16

not, adjust the water softener. Contact your local
water authority to know the water hardness in your
area.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
Adjusting the water softener
German
degrees
(°dH)
47 - 50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
1) Factory position.
2) Do not use salt at this level.
How to adjust the level of the water softener
1. Turn the knob until the programme marker is
aligned with . Make sure that the appliance is
in setting mode.
2. Press and hold the start button until the start indi-
cator, the on/off indicator and
• The intermittent flashing of
current set level,, e.g. 5 flashes + pause + 5
flashes = level 5.
3. Press the start button again and again to change
the setting. Each time you press the start button
the level number increases.
4. To confirm the setting and deactivate the appli-
ance, turn the knob until the programme marker is
aligned with the on/off indicator.
16
Water hardness
French mmol/l
degrees
(°fH)
84 - 90 8.4. - 9.0
76 - 83 7.6 - 8.3
65 - 75 6.5 - 7.5
51 - 64 5.1 - 6.4
40 - 50 4.0 - 5.0
33 - 39 3.3 - 3.9
26 - 32 2.6 - 3.2
19 - 25 1.9 - 2.5
7 - 18 0.7 - 1.8
< 7 < 0.7
start to flash.
refers to the
4. Open the water tap.
5. Processing residues can stay in the appliance.
Start a programme to remove them. Do not use
detergent and do not load the baskets.
Clarke
degrees
58 - 63
53 - 57
46 - 52
36 - 45
28 - 35
23 - 27
18 - 22
13 - 17
5 - 12
< 5
Filling the salt container
Caution! Water and salt can come out from the
salt container when you fill it. Risk of corrosion.
To prevent it, after you fill the salt container, start a
programme.
1
Water softener
adjustment
Level
10
9
8
7
6
1)
5
4
3
2
2)
1
2