ZANKER KDI10001XK Notice D'utilisation page 21

Alarm code
• The start indicator flashes continuously.
• The end indicator flashes 1 time intermittently.
• The start indicator flashes continuously.
• The end indicator flashes 2 times intermittently.
• The start indicator flashes continuously.
• The end indicator flashes 3 times intermittently.
Warning! Deactivate the appliance before you
do the checks. Turn the programme knob until
Problem
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with water.
The appliance does not drain the water.
The anti-flood device is on.
After the checks are completed, activate the appli-
ance. The programme continues from the point of in-
terruption.
If the problem occurs again, contact the Service.
If other alarm codes appear, contact the Service.
If the washing and drying results are not
satisfactory
Whitish streaks or bluish layers on glasses and
dishes
• The released quantity of rinse aid is too much. Ad-
just the rinse aid selector to a lower position.
• The quantity of detergent is too much.
The appliance does not fill with water.
The appliance does not drain the water.
The anti-flood device is on.
the programme marker is aligned with the on/off
indicator.
Possible solution
Make sure that the mains plug is connected to the mains
socket.
Make sure that there is not a damaged fuse in the fuse box.
Make sure that the appliance door is closed.
Press the start button.
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not too low.
For this information, contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not clogged.
Make sure that the inlet hose has no kinks or bends.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
Close the water tap and contact the Service.
Stains and dry water drops on glasses and dishes
• The released quantity of rinse aid is not sufficient.
Adjust the rinse aid selector to a higher position.
• The quality of the detergent can be the cause.
Dishes are wet
• The programme is without a drying phase or with a
low temperature drying phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.
Refer to 'HINTS AND TIPS' for other possible
causes.
Problem
21