Troubleshooting; Alarm Code - ZANKER KDI11002XK Notice D'utilisation

Troubleshooting

The appliance does not start or it stops during opera-
tion.
Before you contact the Service, refer to the informa-
tion that follows for a solution to the problem.

Alarm code

• The start indicator flashes continuously.
• The end indicator flashes 1 time intermittently.
• The start indicator flashes continuously.
• The end indicator flashes 2 times intermittently.
• The start indicator flashes continuously.
• The end indicator flashes 3 times intermittently.
Warning! Deactivate the appliance before you
do the checks. Turn the programme knob until
Problem
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with water.
The appliance does not drain the water.
The anti-flood device is on.
After the checks are completed, turn the programme
knob until the programme marker is aligned with pro-
gramme that was in operation when the problem oc-
curred. The programme continues from the point of in-
terruption.
22
With some problems, different indicators flash
continuously or intermittently at the same time to
show an alarm code.
The appliance does not fill with water.
The appliance does not drain the water.
The anti-flood device is on.
the programme marker is aligned with the on/off
indicator.
Possible solution
Make sure that the mains plug is connected to the mains
socket.
Make sure that there is not a damaged fuse in the fuse box.
Make sure that the appliance door is closed.
Press the start button.
If the delay start is set, cancel the setting or wait for the end of
the countdown.
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not too low.
For this information, contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not clogged.
Make sure that the inlet hose has no kinks or bends.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
Close the water tap and contact the Service.
If the problem occurs again, contact the Service.
If other alarm codes show, contact the Service.
Problem