Panasonic EY7460 Instructions D'utilisation page 9

3. After use, set the lever to its center
position (switch lock).
Clutch Torque Setting
Adjust the torque to one of the 18
clutch settings or "
(EY7460).
Adjust the torque to one of the 18
clutch settings or "
(EY7960).
NOTE:
Always make sure to stop operation
of the tool and disengage it from
the work, when you select Ham-
mering mode from Drilling mode
or when you shift to Drilling mode
from Hammering mode by rotating
clutch handle.
CAUTION:
Set the clutch setting at this mark ( )
before actual operation.
Speed Selection
Choose a low or high speed to suit the
use.
LOW
The more the variable speed control trig-
ger is pulled, the higher the speed be-
comes.
CAUTION:
• Check the speed selector switch
before use.
• Use at low speed when high torque
is needed during operation. (Using
at high speed when high torque
is required may cause a motor
breakdown.)
" position
", " " position
HIGH
• Do not operate the speed selector
switch (LOW-HIGH) while pulling on
the speed control trigger. This can
cause the rechargeable battery to
wear quickly or damage the internal
mechanism of the motor.
* See specifications for "MAXIMUM
RECOMMENDED CAPACITIES".
CAUTION:
• To prevent excessive temperature
increase of the tool surface, do not
operate the tool continuously using
two or more battery packs. The tool
needs cool-off time before switching
to another pack.
• Do not close up vent holes on the
sides of the body during operation.
Otherwise, the machine function is
adversely affected to cause a failure.
• Do NOT strain the tool (motor). This
may cause damage to the unit.
• Use the tool in such a way as to
prevent the air from the body vent
holes from blowing directly onto
your skin. Otherwise, you may get
burned.
Bit-locking Function
1. With the trigger switch not engaged
and a screwdriver bit locked in
place, the tool can be used as a
manual screwdriver (up to 40 N•m,
408 kgf-cm, 353 in-lbs).
There will be a little play in the
chuck, but this is not a malfunction.
2.
This feature is handy for tightening
screws that require more torque
than the maximum torque of the
driver (position
confirming the tightness of a screw or
to loosen an extremely tight screw.
- 9 -
on the clutch), for