Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
SPECIFICATIONS
1. Cordless Circular Saw (C18DL)
Motor
No-load speed
Max. Cutting Depth
Blade Size
Model
Type
Battery
Voltage
Charging & discharging
frequency
Light Bulb
Weight
2. Battery Charger
Model
Input power source
Charging time
Charging voltage
Charging current
Weight
NOTE: The charging time may vary according to ambient temperature and power source voltage.
APPLICATIONS
Cutting Various types of wood.
REMOVAL AND INSTALLATION METHOD
OF BATTERY
How to install the battery.
Align the battery with the groove in tool handle
and install it into place.
Always insert it all the way until it locks in place
with a little click, If not, it may accidentally fall out
of the tool, causing injury to you or someone
around you (Fig. 5).
Handle
Insert
Push
10
ASSEMBLY AND OPERATION
Pull
out
Latch
Battery
Fig. 5
DC motor
3,400/min
2-1/4" (57 mm)
6-1/2" (165 mm) D × 5/8" (15.9 mm) H × 1/16" (1.6 mm) T
EBM1830
Lithium – ion battery
about 1,300 times
7.1 lbs. (3.2 kg)
UC18YRL
Single phase: AC120V 60Hz
Approx. 45 min (At a temperture of 68°F (20°C))
DC 7.2 – 18V
1.3 lbs. (0.6 kg)
How to remove the battery.
Withdraw battery from the tool handle while
pressing the latches on both sides of the battery
(Fig. 5).
CHARGING METHOD
The following is an explanation of charging methods
when using the battery charger UC18YRL.
NOTE
Before plugging into the receptacle, make sure the
following points.
The power source voltage is stated on the
nameplate.
The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on
the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.
1.
Insert the plug of battery charger into the
receptacle.
When the plug of battery charger has been inserted
into the receptacle, the charge status lamp will
blink in red. (At 1-second intervals)
DC 18V
12V, 5W
DC 3.5A
Publicité
Table des Matières
