Humidity And Ultrasonic; Save Settings; Auto" Comfort Mode; Controlling Humidity - Boneco U350 Mode D'emploi

HUMIDITY AND ULTRASONIC

SAVE SETTINGS

The BONECO appliance saves the last-used settings
when it is switched off. However, if the appliance is
disconnected from the power supply for a few sec-
onds, it will start in the operating mode.

"AUTO" COMFORT MODE

After the unit is switched on, it is in
The desired relative humidity (rH) is preset to
50%. The unit chooses the appropriate output
level Low "L" / Medium "M" / High "H", in order to
attain the value of 50% rH as quickly as possible.
In -Mode, the rH can be changed at any time
by using button . If the output level is changed by
using button , the -Mode turns off and the
unit is operated manually.
The heater can be switched on or off without the
appliance leaving mode.
mains active when setting the timer.
To return to mode, tap the

CONTROLLING HUMIDITY

The humidity can be set between 30% and 70%. In
the "Co" setting (for "Continuous"), the ultrasonic
runs regardless of the measured humidity. This
means it does not switch off until the tank is empty
or the appliance is switched off.
-Mode. 1. Tap the symbol. The current humidity indica-
tor starts flashing.
2. While the indicator is flashing, tap the
again until the desired humidity is set.
The value is applied after a few seconds. The indica-
tor stops flashing.
mode also re-
symbol once.

REGULATING PERFORMANCE

1. Tap the symbol multiple times until the de-
sired level appears on the display.
The symbol on the display indicates which of the
three levels (low/medium/high) has been selected:
symbol
15
en